Aerodrums and Aered forums

Hi there,

After testing some apps delivering a lot of loops via BT to follow by
playing along with my AD 2 i would like to test a Mooer GL100. The
specs are looking good so far and Christmas is getting closer :.
My concern is that i might make a mistake with the wiring that will
damage the CPU/System inside. Can i use this looper at all or should i
leave it. Many thanks for any advice.

Greetings from germany

Henrik

Do you have in mind to plug the GL100 into the line-in on Aerodrums 2 so you can play along to the built-in drum grooves from the GL100? Or do you want to plug the Aerodrums 2 headphone output into the input of the GL100 so that you can loop what you play in Aerodrums 2?

In the first case, there is no line-in volume control in Aerodrums 2 so, to be safe, I would set the volume on the GL100 very low to start with. In the second case, you can set the master volume in Aerodrums 2 low to begin with. I don't believe there is much risk of damaging the Aerodrums 2 hardware.

Love to play around with the AD's. It's amazing to hear improvements week by week. My first drumset and I don't miss the rebound ...
I want to plug the Aerodrums 2 headphone output into the input of the GL100 to loop in parallel to a USB C- DAC Dongle Signal delivered from my Smartphones sources plugged in the mono input from the GL100 too. At the end I hope a Y-Cable from the output of the Mooer will end up with my "artwork" in my analog input of a Denon PMA - 60 Amp connected to a pair of KEF Speakers to entertain my neighbours
I will post all updates with an equipment list and some photos

Sounds great. I would love to see/hear a demonstration when you have it set up